The phase is defined by a set of fields in the object catalog entry.
|Parent||P||EJCAT/Body||the parent can be an extended JCAT ID (EJCAT) or a body name.|
|SDate||t1||VagueDate||the phase start time. This can be the time the object separated from the parent EJCAT or the time the object departed the parent body's gravitational sphere of influence (SOI)|
|Primary||C||Body||the name of the central body for this phase|
|DDate||t2||VagueDate||the phase end time|
|Status||S||Phase Status Code||a code describing the event that ends the phase|
|Dest||D||Location/Body/JCAT||`destination', a string whose definition depends on the Status value. It can be empty, a Location, a body, or a JCAT.|
Also relevant is te, the orbit epoch ODate, mentioned in a few cases below.
The symbols in the table above are used in the discussion below for conciseness. A location can be expressed as a string (uncontrolled text, e.g. 'W Atlantic') or as longitude/latitude coordinates (e.g. 74W 22S). The Dest field may be blank if reentry location is unknown.
The different kinds of phases are defined by the Status field. They are given in a somewhat arbitrary order that makes sense to me, and grouped by what kind of Dest field is used. The state of an object includes its `externality' - is it free, attached to a parent object externally, or is it inside its parent object. This externality is also described in the following table defining the different Status codes. The table assumes (in the interpretation of t1 and t2) that P is a EJCAT rather than a body. If P is a body then t1 represents the time the object went from P's SOI to C's SOI; if D is a body then t2 represents the time the object went from C's SOI to D's SOI.
(Added 2021 Oct:) For cases where a vehicle is reused in a new launch (e.g. Space Shuttle Orbiter), the REFLT status is used to connect the objects. For example, the Space Shuttle OV-102 Columbia flew on mission STS-1 as orbital launch 1981-034, catalog S12399, piece designation 1981-034A. When it flew again on STS-2, NORAD gave it a new launch number 1981-111, catalog number S12953, and piece designation 1981-111A. Understandably the NORAD (now Space Force) tracking system cannot know from tracking data that the objects are the same vehicle - but historians do. I add an extra phase to S12399 (STS-1) after the landing, with zero duration, status REFLT, and dest equal to S12953, to signal that S12399 later got relaunched as S12953. Note that only a few entries of this kind have been added at the time of this writing.
I acknowledge that there is a bit of a `ship of Theseus' problem here: is the orbiter that flew on STS-93 really the `same object' as the one that flew STS-1?
The case of re-launches from other worlds is slightly different, in that Space Force does NOT assign a new catalog number, but I do - when the launch is from a world, not a small rock. For Apollo 11, three objects get new catalog numbers: the LM 5 Eagle ascent stage and the two EVA suits. EVA suit A7L-056 was given auxiliary catalog A01625 for its launch from Earth (launch designation 1969-059). On reaching deep space aboard Eagle it is given designation D00265. The last A01625 phase has status DSA with dest D00265 to tie the two together. The suit retains its D00265 designation through the lunar surface EVAs. Then it has a phase with the REFLT tag reassigning it to a new catalog number D01053 associated with a new launch, 1969-U01, corresponding to the launch of Eagle from the lunar surface. This follows the spirit of what NORAD did with STS-1 - when relaunching the same thing it gets new launch designations and catalog numbers - even though NORAD does not actually do this when the launch is not from Earth. Suit A7L-056 retains the new D01053 catalog number and 1969-U01 launch designation through its landing in the Pacific aboard D00273/1969-059A Columbia.
For the actual extraterrestrial re-launching itself, I retain the `LO' status tag used previously but add a dest value. `LO' should now be considered as equivalent to REFLT for such cases. Thus, for Eagle's ascent stage we have: launched from Earth as 1969-059C, catalog S04041. Reached deep space and reassigned as 1969-059C, catalog D00274, via a DSA status tag to connect the catalog numbers. Relaunched from the Moon as new launch 1969-U01, catalog D01052. The final D00274 phase has status LO with dest D01052 to connect it to the new catalog number.
For `launches' (departures) from low gravity objects that I don't count as worlds, I don't give new launch designations. I think of it more like an undocking in such cases! In these cases, the LO status tag does not have a new catalog number in the Dest field.
In earlier versions of the catalog, I did not distinguish between planetary flybys and orbital missions. Both used the 'EO' take for a swich of sphere of influence. For an orbital mission, however, the phase within the planetary sphere of influence includes three sub-phases: hyperbolic approach from sphere of influence to orbit insertion, elliptical bound orbit phase, and (hyperbolic) departure from orbit escape to sphere of influence (or to impact/landing).
In versions prior to 1.4, suborbital objects were given status 'R'. However their reentry, although it doesn't involve a deorbit burn, is at a predictable time and targeted location, which is importantly different from uncontrolled reentries of orbital objects. The new status value 'S' is now used for suborbital targeted reentries and also (a bit more questionably) for launch failures. The 'LF' code for failed landing has not been used generally - some 'D' should really be 'LF'.
|Cases with t2 and Dest both empty|
|O||In orbit||Sep from P at t1, still in free flight||Free|
|AO||Attached in orbit||Attached to P from t1 to present||External|
|AO IN||Attached inside||Inside P from t1 to present||Internal|
|UDK||Undocked||Docked to P from t1 to t2, sep from P at t2||External to free|
|REL||Released||Attached to P from t1 to t2, sep from P at t2||External to free|
|DEP||Deployed||Same as REL but for objects on planetary surface||External to free|
|TO||Takeoff||Launch from C surface (C is a small body, not a world)||Free|
|TOA (was ALO)||Attached at takeoff||Attached to P from t1 to t2 including at launch from C surface.||External|
|OX||In orbit (probably) but lost||As O, but no recent tracking data||Free|
|Dest is always blank but t2 is not|
|E||Exploded||Sep from P at t1, free in orbit until breakup at t2. Next phase of this object is a debris fragment.||Free|
|N||Renamed||In orbit from t1 to t2, name or owner changed at t2. Next phase reflects new name and owner||Free|
|NA||Renamed attached||Attached to P from t1 to t2, name or owner changed at t2. Next phase reflects new name and owner||External|
|LEASE||Lease||Temporary lease from main owner from t1 to t2. SatType code is PA.||Free|
|Dest is a location on C, or C itself, or blank (see also 'Dest is a body name' below)|
|S||Targeted suborbital entry/impact||Sep from P at t1, crashed or destroyed in atmosphere at t2 at end of launch trajectory||Free|
|R||Reentered||Sep from P at t1, destroyed in C's atmosphere at t2 after natural decay||Free|
|D||Deorbited||Sep from P at t1, destroyed in C's atmosphere at t2 via active deorbit maneuver||Free|
|L||Landed||Sep from P at t1, landed or splashed down on C's surface at t2||Free|
|LF||Failed landing||Intact landing intended but actually destroyed on impact||Free|
|AS||Suborbital reentered attached||Attached to P from t1 to t2 when P reentered||External|
|AR||Reentered attached||Attached to P from t1 to t2 when P reentered||External|
|AR IN||Reentered inside||Inside P from t1 to t2 when P reentered||Internal|
|AL||Landed attached||Attached to P from t1 to t2 when P landed||External|
|AL IN||Landed inside||Inside P from t1 to t2 when P landed||Internal|
|TX||Transmission ended||Operated on C's surface from t1 to t2||Free|
|F||Failed||Sep from P at t1, crashed or destroyed at t2 during launch failure||Free|
|AF||Failed attached||Attached to P at all times until it and P crashed or destroyed at t2 during launch failure||External or internal.|
|Dest is a JCAT from D catalog (deep space). JCAT ID used in deep space catalog for this object is given by the Dest value.|
|DSO||Deep space||Sep from P at t1, passed deep space boundary at t2.||Free|
|DSA||Deep space attached||Attached to P since t1, passed deep space boundary at t2.||External|
|DSA IN||Deep space inside||Inside P since t1, passed deep space boundary at t2.||Internal|
|LO||Liftoff||Launch from C surface (C is a world but not Earth), catalog reassigned to dest||Free|
|LOA||Reflight attached||Launch from C surface (C is a world but not Earth) aboard parent object, catalog reassigned to dest||External or Internal|
|Dest is a JCAT from the main catalogs (not from D catalog)|
|DK||Docked||Sep from P at t1, docked with D at t2||Free to External|
|GRP||Grappled||Sep from P at t1, docked with D at t2||Free to External|
|ATT||Attached||Was attached to P at t1, then attached to D at t2||External.|
|TFR||Transfer||Inside P at t1, moved inside D at t2||Internal|
|TFR E||Transfer external||Inside P at t1, moved to exterior of D at t2||Internal to External|
|TFR IN||Transfer in||Outside P at t1, moved to interior of D at t2||External to Internal (same as RET)|
|C||Collided||Collided with D at t2||Free|
|EVA DP||Spacewalk (depress)||Inside P at t1, began depressurization of airlock of D at t2||Internal to External|
|EVA RP||Spacewalk (repress)||Depressurized airlock of P at t1, repressurized airlock of D at t2||Internal to tethered or free to Internal|
|REFLT||Reflight||Object reassigned to a new catalog number on its next flight||Not applicable|
|Dest is a body name|
|EO||Escape||Left P's SOI at t1, In C's SOI from t1 to t2, entered D's SOI at t2||Free|
|EAO||Escape attached||Attached to P from t1 to t2. In C's SOI till t2, then in D's SOI||External|
|EN||Encounter||same as EO, but denotes specifically a single flyby of the central body P with periapsis time equal to te (ODate value), before departing the SOI at t2.|
|OI||Orbit insertion||Left P's SOI at t1, entered C's SOI at t1 and entered a bound orbit around C at t2. This will be paired with a next phase with an empty Parent (implied equal to C) describing the phase that begins with orbit insertion and ending with landing, impact or orbit departure OE.|
|OE||Orbit escape||In orbit around C at t1, performed escape burn at t2. Next phase will describe the phase from escape burn to departing sphere of influence.|
|ERR||Error||No object corresponding to this entry (tracking or cataloging errors)||-|
For case C (Collision) the collision can result in the destruction of the object, in which case there is no subsequent phase; or the object can survive, in which case t2 starts a new phase. If object A collides with object B, there is a C status for each of the objects A and B. That is, A has a phase that ends with 'A collides with B', and B has a phase that ends with 'B collides with A'. If A survives, B is the parent object for A's next phase, and vice versa.
For cases R, D, AR, AR IN: if C has no atmosphere, t2 is the time of impact on C's surface. Natural decay includes orbit perturbation due to mascons, and direct impact without first entering bound orbit.
For cases DSO, DSA, DSA IN; the object is considered to have left the main part of GCAT at t2. Its old JCAT ID no longer applies and the Deep Space Catalog JCAT ID is used for further phases of its history.
For case LO, when taking off from a world a new launch designation and catalog number are assigned - it is treated as a new launch. For case TO, when taking off/departing from a small body, I don't consider it a new launch and no reassignment is made.
For case EVA RP, P and D are usually the same airlock. The phase may involve moving outside airlock and returning (`spacewalk'), but sometimes the `EVA' may be entirely internal, working inside the depressurized airlock for the duration. Sometimes I use the phrase `depressurization activity' rather than 'EVA', since the initial E is not necessarily applicable.
The cases OI, OE, EN, EO and EAO are only used in the Deep Space Catalog and the heliocentric and lunar-planetary registers.